Reflection Slide Toppers

[Scousers]

Our 303RLS has the dining room awning, but it now appears to be OK

[Johnww]

We have slide out toppers on our 2019 303 RLS installed be the dealer. No clearance issues with awnings.

[Bamaman]

My dealer wanted $2,000 for 4 slide covers on my Reflection. I consider slide covers another profit center for that dealer.

You can buy them online very reasonably. And they are not at all difficult to install. Just beware that the slide to the left of your front door requires a slightly shorter topper because the door facing on the left side of the door is not very wide. The slide topper can hit the frame on your awning so it needs to be one size shorter than you'd normally use.

[Country Campers]

Thank you Dan,
It does appear that the dinette slide awning can cause an issue for sure and the mounts do it fact get attached to the flange

The bracket is not actually mounted to the flange. In the second picture in post #2 you can see the mounting screws for the top of the awning and just above that the mounting plate for the topper. The bracket for the topper is offset so it comes out then goes up over the flange of the slide. There are no mounting brackets that go into the flange on the slide.

Brian

[James Callahan]

Brian,
Can’t get the picture your referencing to display

[Country Campers]

https://www.mygrandrv.com/fo...per+reflection

Post #2 of this thread referenced earlier, sorry. I have a touch screen so I can zoom in on the mount.

Brian

[James Callahan]

Brian,
Thanks I to can zoom up on this, it essentially buts up against awning bracket, by any chance can you make out who the manufacturer is?
Thank you for your help

[Country Campers]

Not sure who the manufacture is. Maybe @Hunter70 can get us that info.
Mine is carefree I think , will check tomorrow. Mine does not sit that high above the flange and also has a center roller support that keeps tension on the roller to reduce flapping and water ponding. Also sits closer to the top flange. Maybe I will get some pics of mine tomorrow.

Brian

[James Callahan]

Not sure who the manufacture is. Maybe @Hunter70 can get us that info.
Mine is carefree I think , will check tomorrow. Mine does not sit that high above the flange and also has a center roller support that keeps tension on the roller to reduce flapping and water ponding. Also sits closer to the top flange. Maybe I will get some pics of mine tomorrow.

Brian

Thank you Brian, I appreciate all the correspondences.
Jimmy

[huntr70]

Not sure who the manufacture is. Maybe @Hunter70 can get us that info.
Mine is carefree I think , will check tomorrow. Mine does not sit that high above the flange and also has a center roller support that keeps tension on the roller to reduce flapping and water ponding. Also sits closer to the top flange. Maybe I will get some pics of mine tomorrow.

Brian

They are Dometic/ A&E toppers.