Schwintek Slide Stuck

[Dave27]

They are located on the top corner of each slide. Most often you can usually remove the rubber seals inside the coach with the slide partially in to access from inside of the coach. Motor retention screw is on the exterior top for a manual override. On the slide controller you can electronically override by pressing the push button on the slide controller box 6 times, hold the 7th time for 5 secs. Green Red lights will flash back and forth.

Where is the slide controller located?
Dave

[Agpopp]

Where is the slide controller located?
Dave

It's in the basement mounted to the ceiling on my 317 5th wheel.

Sent from my SM-G900V using Tapatalk

[CoChris]

Very interesting stuff. I can't find the slide controller on my 2400BH, I also don't think it is shown in the manual. I have not extensively looked for it, I just want to be ready, just in case.

Controller will look like



In a 5th wheel it is typically located on the ceiling of the front (battery) compartment. I do not know where it would be located in a TT.

Chris

[Lizardqing]

Where is the slide controller located?
Dave

It is under the outdoor kitchen stove in our Reflection 312BHTS. Have to pull the drawer all the way out and then use some contortionist magic to look at and press the button and see the led lights. Had to do the manual override hint the other day to get our slide back synchronized.

[Dave27]

I found them. They are on the ceiling of the pass through, near where the auto level control is. I knew there was something up there, but didn't know what it was. I don't know how I will be able to read them, but at least I know where they are and what they do. It sounds like they can be anywhere based on the answers here.

thanks,
Dave

[gengiant]

I just pulled out my invoice from LCI for the replacement Schwintek motor on my previous camper. The invite is dated 10/18/2015 and was for $228 (incl. S & tax). Note that at the time, Schwintek offered two different motors, one significantly stronger/more powerful than the other. Mine was the smaller of the two. However, the two were not interchangeable as they each used their own unique track/framing (so I was told by LCI)


Sent from my iPhone using Tapatalk

[MidwestCamper]

Controller will look like



In a 5th wheel it is typically located on the ceiling of the front (battery) compartment. I do not know where it would be located in a TT.

Chris

In the Imagine 2600RB there is a removable panel in the area under the bathroom sink. I had to bypass on a trip where the encoder was also bad on one of my motors. General RV replaced the motor and its been good since that time.

[Agpopp]

I found them. They are on the ceiling of the pass through, near where the auto level control is. I knew there was something up there, but didn't know what it was. I don't know how I will be able to read them, but at least I know where they are and what they do. It sounds like they can be anywhere based on the answers here.

thanks,
Dave

Even on mine I had to lay on my back in the compartment to see what I was doing.

Sent from my SM-T350 using Tapatalk

[J&G garage]

I found them. They are on the ceiling of the pass through, near where the auto level control is. I knew there was something up there, but didn't know what it was. I don't know how I will be able to read them, but at least I know where they are and what they do. It sounds like they can be anywhere based on the answers here.

thanks,
Dave

Take a video of the controller lights with your phone and play it back to see the codes.

[Dave27]

Take a video of the controller lights with your phone and play it back to see the codes.

good idea, thanks!